Amazon Video

Avid 4848 Pro Assembly – Gantry, Rack and Pinion, and Electronics

Avid 4848 Pro Assembly – Gantry, Rack and Pinion, and Electronics
Click MORE!

In this video, I’ll finish the assemble my new Avid CNC 4848 Pro router! First I’ll show you how I assembled the Gantry. I’ll then assemble and mount the Pack and Pinion drives. Then I’ll show you the installation of the Z axis and 4 hp air-cooled spindle. I’ll give you a peek into what is involved in mounting the cable tracks, running all the cables, and mounting the electronics boxes.

Finally, I’ll give you couple more tips that I picked up while finishing up the assembly.

As usual, if you have any comments or questions about anything I covered in this video, please join me for the Live Q&A, or put ‘em in the comment section below.

On Sunday, July 24th, I’ll be hosting a LIVE Q&A session, where you can ask your questions pertaining to anything I’ve covered in this video. That Q&A starts at 3 pm Eastern time, Noon Pacific time. Hope to see you there!

Here’s a link to the Live Q&A:

Link to the 6mm long reach Ball End Hex driver bits I used:
Link to Metric Ball End Hex Key set I used:
Link to Metric Ball End Hex screwdriver bit set:

For more info, or to configure an Avid CNC of your own, visit their website:
If you’d like to support my channel and help with the making of future videos, please consider becoming a channel member. If you’d rather make a one-time donation, you can do that by using the following link:

Direct link to more information on becoming a Channel Member:
Thank you very much!
Link to the Vectric for the Absolute Beginner Playlist:
Link to the 3D Modeling for the Absolute Beginner playlist:
Link to the V-Carving for the Absolute Beginner playlist:
Get your Official Mark Lindsay CNC T-shirts and coffee mugs here: is sponsored by Harneal Media – a website developing company that specializes in websites for the maker community. Find out more at:
Link to The Trampled Underfoot Podcast, hosted by my friend Eloy Escagedo and I. “Two guys from different decades, backgrounds, and opposite sides of the continent discuss life, the universe, and everything. What’s the show about? About an hour…”
Facebook Page:
Past Episodes available at our website:
For more information on, or to download a free trial of Cut 2D, VCarve, or Aspire, visit the Vectric website at:
Some links may be affiliate or sponsor links. Purchasing or even clicking through these links helps with the making of future videos.
I appreciate your support!
This video is for informational and entertainment purposes only.
#avidcnc #4848Pro #cncrouter

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.